#Vango airbeam valves zip#

If an AirPole has lost pressure, then the seal between one of the connecting hoses and the isolation valves may have become loose. Wait for a period of time and recheck the pressure in all the AirPoles by squeezing the poles. Go inside the awning and close all of the isolation valves. If you suspect that the awning may be leaking some air then it is more than likely that one, or more of the connections will need to be adjusted. This is not a fault with the awning but a maintenance procedure that may have to be performed from time to time. Each awning is fully inflated and tested before leaving the factory but the repeated folding, transporting, unfolding and setting up process can sometimes pull on the connection causing it to loosen. Occasionally, the connection between the connecting hoses and the isolation valves can work themselves loose. ▪ To aid lubrication you can use a little washing up liquid, dry this off before fitting back onto the awning. ▪ With regards to the inflation valve area, the tolerance between the fitting and the diameter of the sleeve is very small, this is to minimise the risk of the bladder twisting. ▪ Tuck any excess bladder around this strap, once only and allow it to lie flat before zipping up. ▪ Please be aware that the bladder may be slightly longer than the sleeve, this is normal, you will notice that there is a black elasticated strap at the far end of the sleeve. FITMENT OF MAIN BLADDER TO SLEEVE ▪ We would recommend that both bladder and sleeve are placed on a firm, flat and solid surface.

#Vango airbeam valves zip#

Reassemble the AirPole, zip back into the sleeve and reconnect the hoses to the isolation Spares are available from your dealer or direct from Kampa.Ħ. Another alternative is to replace the tube.Follow the manufacturer instructions to repair. The repair can be enhanced by using a combination of the above and product CA9011 - Kampa Repair Solution, which is a flexible adhesive (repair tape and repair solution are available together in kit form).We recommend product CA9001 - Kampa Awning & Tent Repair Tape. Once the puncture has been located the bladder can be repaired using repair tape. For small holes it may be necessary to submerge the bladder in water. This is made easier if you blow some air into the tube. Unzip the protective sleeve of the AirPole to expose the bladder (inner tube). NEVER OPEN THE ZIP ON A PROTECTIVE SLEEVE WHILST AN AIRPOLE IS INFLATED. You should now be able to remove the AirPole. There may be multiple valves per AirPole. Undo the compression fittings on the affected side of the isolation valve. Unzip the outer sleeve holding the AirPole. VIEW ALL CARAVAN & MOTORHOME ACCESSORIESĬOVERS - UNIVERSAL GARDEN FURNITURE COVERSįor AirFrame system awnings you can remove an AirPole when the awning is inflated or deflated but if it’s inflated the isolation valves around the AirPole must be closed.The AirSpeed tubes are quick and easy to change, so that you can carry on with your camping holiday as soon as possible! Simply remove the old tube from the beam sleeve and replace with the new tube. Vango never comprise on quality, so you can feel confident that these products have been thoroughly tested and are built to Vango's exacting standards.

It's always a good idea to keep a spare AirSpeed tube with you to ensure that your holiday doesn't come to an abrupt end. You will simply need to secure the valve in the correct location and fold back the excess before inflation, the housing sleeve will stop the tube from expanding any more than is required. Important:Replacement tubes will be supplied longer than the beam sleeve length, in some cases the replacement tube may be slightly longer and wider than your original (upto 80cm longer). This item is a genuine Vango product, manufactured from 100% TPU Tube with the AirSpeed Valve system.